Specifically for bone, but I’m pretty sure anything you share about other tissues also can be helpful. Thanks!!

Hi everyone,

I recently bought a used Ender 3 V2 Neo and brought it to work to experiment with using it as a bioprinter. I came across this guide (link down below) followed the instructions, printed all the required parts, and assembled them.

I also adjusted all the necessary settings they provided for printing. After downloading the model I wanted, I imported it into Cura 5.9, sliced it, and attempted to print. However, the printer only moved briefly and then immediately finished the job without dispensing even a single drop of my solution through the needle.

My question is: has anyone encountered this issue, or does anyone know why this might be happening?

LINK: https://journals.asm.org/doi/10.1128/jmbe.00124-22

I wanted to build diy bioprinter out of my ender 3 but didn't find any good projects so i wanted to ask maybe someone has good project that works well just like factory solution?

My daughter has a research class in high school, and she her subject is bioprinting. Does anybody know where she could get a tour of a facility or school that specializes in bioprinting?